GreenWorks G24LT30 Manual Del Operario página 9

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 21
EN
when trimming efficiency diminishes. This will maintain best
performance and keep the line long enough to advance
properly.
5.7
ADJUST THE LENGTH OF THE
SHAFT
Figure 12.
You can adjust the length of the shaft to operate the
machine easily.
1. Stop the machine.
2. Unlock the cam lever and move the lower shaft to the
desired position.
3. Lock the cam lever.
5.8
CHANGE TO THE EDGING MODE
Figure 13 - 14.
You can change the machine to a well groomed edger for
edging patios, driveways and walkways or other areas.
1. Stop the machine.
2. Use a foot to hold the guard to rotate the trimmer head.
3. Turn the trimmer head to the same level as the shaft.
4. Unlock the cam lever and turn the trimmer head 90
degrees until the trimmer head locks into position.
5. Lock the cam lever.
5.9
OPERATION TIPS
Figure 15.
Keep clearance between the body and the machine.
Do not operate the machine without guard in place.
Follow these tips when you use the machine:
Keep the machine connected to the correctly worn
harness.
Keep a firm hold with two hands on the machine while
you operate the machine.
Cut tall grass from the top down.
If grass winds around the trimmer head:
First, remove the battery pack.
Then, remove the grass.
NOTE
NOTE
WARNING
WARNING
English
5.10
CUTTING TIPS
Figure 16.
Tilt the machine towards the area to be cut. Use the tip of
the cutting line to cut grass.
Move the machine from right to left to prevent thrown
debris toward the operator.
Do not cut in dangerous areas.
Do not force the trimmer head into uncut grass.
Wire and picket fences cause cutting line wear and
breakage. Stone and brick walls, curbs, and wood can
wear the cutting line quickly.
6
MAINTENANCE
Read and understand the safety regulations and the
maintenance instructions before you clean, repair or do the
maintenance work on the machine.
Make sure that all nuts, bolts and screws are tight. Check
regularly that the handles are firmly mounted.
Use only the replacement parts and accessories of the initial
manufacturer.
6.1
GENERAL INFORMATION
Only your dealer or approved service center can do the
maintenance that is not given in this manual.
Before the maintenance operations:
Stop the machine.
Remove the battery pack.
Cool the motor.
Store the machine in a cool and dry place.
Use correct clothing, protective gloves and safety glasses.
6.2
CLEAN THE MACHINE
Clean the machine after each use with a moist cloth
dipped in neutral detergent.
Do not use aggressive detergents or solvents like "glass
cleaner" to clean the plastic parts or handles.
Keep the trimmer head free from grass, leaves, or
excessive grease.
Keep the air vents clean and free of debris to avoid
overheating and damage of the motor.
Do not spray water onto the motor and electrical
components.
6
IMPORTANT
IMPORTANT
IMPORTANT
IMPORTANT
loading

Este manual también es adecuado para:

Stg311