Remote Control - cecotec CONGA 1390 Serie Manual De Instrucciones

ENGLISH

REMOTE CONTROL

ON/OFF/STANDBY/SLEEP
1. ON/OFF
• Make sure the robot's power switch is ON.
• During standby mode, press
robot up.
• During sleeping status, press
again to start cleaning.
2. Standby
During this status, the robot is switched on and waiting for user operation.
• During operation, press
3. Sleep
During sleep status, press
• During standby mode, press
• During standby mode, the robot will enter sleep mode after 10 minutes of no
operation.
WATER INTENSITY/TIME SETTINGS
1. Water intensity
• Short press
between 1: high, 2: medium, or 3: low. The display will show 1, 2 or 3 and the robot
will emit the number of beeps respectively.
2. Timer settings
• Long press the
buttons to select the desired hour and minutes, and then short press
the settings.
POWER
• Long press the POWER button for 3 seconds to select the suction power level.
Choose between 1: high, 2: medium or 3: low. The display will show 1, 2 or 3 and the
robot will emit the number of beeps respectively.
TIME AND SCHEDULE SETTINGS
1. Setting time from the remote control
• Press any button from the remote control to turn the display on. The display will
show the remote control's current time and day.
• Long press
26
on the robot or on the remote control to start the
once to switch the robot to standby mode and then
to stop and switch the robot to standby mode.
on the robot or on the remote control to start the robot up.
on the robot for 5 seconds to enter sleep mode.
to adjust the water intensity during scrubbing mode. Select
button to enter the time-settings mode. Use the direction
the left 2 digits will blink. Use buttons
to save
and to increase or