Programming - Marmitek TMD4 Modo De Empleo

PROGRAMMING

Note: switch on the main master switch first before you start
programming.
Activate setup mode
To program the MicroModule it should be set in the 'setup' position.
This works as follows:
Press the program button for minimal 3 seconds after which the red
LED stays on. Now the button can be released.
Warning: When no installation command is received within 60
seconds, the module leaves the program position automatically.
De-activate setup mode
• Press the program button once shortly: the red
LED is off now or wait for about 60 seconds
until the program position is released.
yellow
orange
Activate and de-activate of the program position.
Programming of the address and the options
In the table you find the possible set-ups of the TMD4
Factory defaults
Address A1
No DIM/BRIGHT
Does not respond to 'all lights on'
Does not respond to 'all units off'
TMD4™
P
prog.
N
blue
red
brown
programmable
Address A2.....P16
DIM/BRIGHT
responds to 'all lights on'
responds to 'all units off'
L
command LED flashes
2 x Address 2 x
2 x DIM 5 x
2 x 'all lights on' 6 x
2 x 'all units off' 8 x
11