Idiomas disponibles
Idiomas disponibles
• do not operate charger if it has
received a sharp blow, been dropped,
or otherwise damaged in any way.
Take it to an authorized service center.
• do not disassemble charger; take it
to an authorized service center when
service or repair is required. Incorrect
reassembly may result in a risk of electric
shock, electrocution or fire.
• disconnect the charger from the
outlet before attempting any cleaning.
This will reduce the risk of electric shock.
Removing the battery pack will not
reduce this risk.
• NeveR attempt to connect 2 chargers
together.
• The charger is designed to operate on
standard household electrical power
(120 volts). do not attempt to use it on
any other voltage.
SAve THeSe INSTRucTIoNS
Important Safety Instructions for
Battery Packs
WARNING
:
For safe operation, read
this manual and manuals originally supplied
with tool before using the battery pack.
The battery pack is not fully charged out of
the carton. Before using the battery pack and
charger, read the safety instructions below.
Then follow charging procedures outlined.
ReAd All INSTRucTIoNS
• do not incinerate the battery pack
even if it is severely damaged or is
completely worn out. The battery pack
can explode in a fire. Toxic fumes and
materials are created when Li-Ion battery
packs are burned.
• do not charge or use battery in
explosive atmospheres, such as in the
presence of flammable liquids, gases or
dust. Inserting or removing the battery from
the charger may ignite the dust or fumes.
• If battery contents come into contact
with the skin, immediately wash area
with mild soap and water. If battery liquid
gets into the eye, rinse water over the
open eye for 15 minutes or until irritation
ceases. If medical attention is needed,
the battery electrolyte for Li-Ion batteries
is composed of a mixture of liquid organic
carbonates and lithium salts.
• contents of opened battery cells may
cause respiratory irritation. Provide
fresh air. If symptoms persists, seek
medical attention.
WARNING
:
Burn hazard. Battery liquid
may be flammable if exposed to spark or flame.
• Charge the battery packs only in
PoRTeR-cABle chargers.
• do NoT splash or immerse in water
or other liquids. This may cause
premature cell failure.
• do not store or use the tool and battery
pack in locations where the temperature
may be reach or exceed 105°f (40˚c)
(such as outside sheds or metal
buildings in summer).
WARNING
:
battery pack for any reason. If battery pack
case is cracked or damaged, do not insert
into charger. Do not crush, drop or damage
battery pack. Do not use a battery pack or
charger that has received a sharp blow, been
dropped, run over or damaged in any way
(i.e., pierced with a nail, hit with a hammer,
stepped on). Damaged battery packs should
be returned to service center for recycling.
WARNING
:
or carry battery so that metal objects can
contact exposed battery terminals. For
example, do not place battery in aprons,
pockets, tool boxes, product kit boxes,
drawers, etc., with loose nails, screws, keys,
etc. Transporting batteries can possibly
cause fires if the battery terminals
inadvertently come in contact with
conductive materials such as keys, coins,
hand tools and the like. The US
Department of Transportation Hazardous
Material Regulations (HMR) actually prohibit
transporting batteries in commerce or on
airplanes (i.e., packed in suitcases and
carry-on luggage) UNLESS they are properly
protected from short circuits. So when
transporting individual batteries, make sure
that the battery terminals are protected and
well insulated from materials that could
contact them and cause a short circuit.
NOTE: Li-Ion batteries should not be put
in checked baggage.
Storage Recommendations
1. The best storage place is one that is
cool and dry away from direct sunlight and
excess heat or cold.
2. Long-term storage will not harm the
battery pack or the charger as long as the
battery is not depleted.
charging Procedure
PoRTeR-cABle chargers are designed
to charge PoRTeR-cABle battery packs.
Charge times are: PCC690L in 40-80
mins., PCC691L in 70-140 mins., PCC692/
PCC692L in 40-80 mins., and PCC695L
in 180-360 mins. depending on the pack
being charged.
1. Plug the charger into an appropriate
outlet before inserting the battery pack.
2. Insert the battery pack into the charger.
3. The LED will flash indicating that
the battery is being charged.
6
Never attempt to open the
fire hazard. do not store
