Desa LGFB32C Información De Seguridad Y Manual De Instalación página 9

Calefactor universal no ventilado (sin ventilación)
Idiomas disponibles

Idiomas disponibles

5. Connect wires from the electrical box to
duplex outlet. Match wire colors to those
indicated on duplex outlet. Be sure to
connect ground wire.
6. Replace duplex outlet with screw.
7. Plug blower power cord into duplex outlet.
8. Replace bottom of firebox.
Blower
Support Bracket
Blower Power Cord
Figure 9 - Routing Blower Accessory
Power Cord for Built-In Installation
operating Blower
Light your gas appliance with the blower off.
After about 15 minutes, turn the blower on
to deliver heated air at the top louvers. The
blower features a variable control which al-
lows you to select the speed you desire.
Note: Periodically check the louvers of the
firebox and remove any dust, dirt or other
obstructions.
INstAllING loG heAteR IN
fireBox
cautioN: do not pick up log
base assembly by burners. this
could damage burners. only
handle base by grates.
cAutIoN: do not remove the
data plates attached to the heater
base assembly. the data plates
contain important warranty and
safety information.
1. Remove 4 screws holding firebox bottom
in place.
119505-01E
INSTALLATION
Continued
Cables From
Electrical Source
Duplex
Outlet
Screw
www.desatech.com
2. Lift and remove firebox bottom (see
Figure 10).
3. If installing GA3750A blower accessory,
see Installing Blower Accessory, page 8.
4. Route flexible gas line from equipment
shutoff valve into firebox through side.
Notice: most building codes
do not permit concealed gas
connections. a flexible gas line
is recommended to allow acces-
sibility from the firebox. the flex-
ible gas supply line connection
to the equipment shutoff valve
should be accessible.
5. Attach gas log heater base to firebox bot-
tom with four screws included with base
(see Installing Heater Base Assembly in
log set owner's manual).
6. Replace firebox bottom and secure with
screws.
Figure 10 - Removing Firebox Bottom
INstAllING FIRePlAce hood
Notice: the firebox canopy (hood)
must not be modified or replaced
with a canopy (hood) that may be
provided with the unvented decora-
tive room heater.
1. Attach three zinc-colored shoulder screws
to back of hood.
2. Insert hood into hood-mounting slots on
firebox.
3. Hold hood in place. Insert two black Phil-
lips screws through bottom of hood and
tighten. See Figure 11, page 10.
9
loading