Idiomas disponibles
Idiomas disponibles
Hood
Figure 11 - Installing Fireplace Hood
INstAllING FIRePlAce scReeN
1. Insert each rod through nine rings located
at top of screen (see Figure 12).
2. Insert first rod into rear hole in left side
of firebox. Fasten rod to rear hole near
center of firebox using black shoulder
screw.
3. Insert other rod into front hole on right
side of firebox and fasten using remaining
shoulder screw.
Screw
Front and
Rear Hole
Rod
Ring
Screen
Figure 12 - Installing Fireplace Screen
fireBox iNstallatioN usiNG
oPtIoNAl AccessoRy MANtels
This firebox may be installed using the corner
or cabinet mantel with hearth base against
a wall in your home. A perimeter trim kit is
included with the mantel accessories (see
Accessories, page 13).
10
INSTALLATION
Continued
Built-iN fireBox iNstallatioN
Hood
Built-in installation of this firebox involves
Mounting
installing firebox into a framed-in enclosure.
Slot
This makes the front of firebox flush with wall.
Optional perimeter trim is available (see Ac-
cessories, page 13) This perimeter trim will
Shoulder
extend past sides of firebox approximately
Screw
1/2". This will cover rough edges of the wall
opening. If installing a mantel above the fire-
Screw
box, you must follow the clearances shown in
Figure 7, page 8. Follow the instructions below
to install the firebox in this manner.
1. Frame in rough opening. Use dimensions
shown in Figure 13 for the rough opening.
If installing in a corner, use dimensions
shown in Figure 14 for the rough opening.
The height is 33", which is the same as
the wall opening in Figure 13.
2. Install gas piping to firebox location. This
installation includes an approved flexible
gas line (if allowed by local codes) after
the equipment shutoff valve. The flexible
gas line must be the last item installed on
the gas piping. See Connecting to Gas
Supply in log set owner's manual.
3. Carefully set firebox in front of rough open-
ing with back of firebox inside wall opening.
IMPORTANT: If installing perimeter trim,
see instructions included with perimeter
trim accessory. You must install shoulder
screws now.
Figure 13 - Rough Opening for Installing
Figure 14 - Rough Opening for Installing
www.desatech.com
17
33"
34
/
3
in Wall
39
"
/
3
8
34
"
/
3
4
55
"
/
5
8
in Corner
3
/
"
4
"
4
27
"
/
7
8
119505-01E
