Bosch 2800 RE Manual Original página 23

OBJ_BUCH-318-003.book Page 23 Friday, November 19, 2010 4:36 PM
Noise/Vibration Information
Measured sound values determined according
to EN 60745.
Typically the A-weighted noise levels of the
product are: Sound pressure level 89 dB(A);
Sound power level 100 dB(A). Uncertainty
K =3 dB.
Wear hearing protection!
Vibration total values (triax vector sum) deter-
mined according to EN 60745:
Hammer drilling into concrete: Vibrational emis-
2
sion value a =16 m/s , uncertainty K=1.5 m/s
h
Chiselling: Vibrational emission value
2
a =14 m/s , uncertainty K=1.5 m/s
h
Drilling in metal: Vibrational emission value
2
a <2.5 m/s , uncertainty K=1.5 m/s
h
Screwdriving without impact: Vibrational emis-
2
sion value a <2.5 m/s , uncertainty K=1.5 m/s
h
The vibration emission level given in this infor-
mation sheet has been measured in accordance
with a standardised test given in EN 60745 and
may be used to compare one tool with another.
It may be used for a preliminary assessment of
exposure.
The declared vibration emission level repre-
sents the main applications of the tool. However
if the tool is used for different applications, with
different accessories or poorly maintained, the
vibration emission may differ. This may signifi-
cantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibra-
tion should also take into account the times
when the tool is switched off or when it is run-
ning but not actually doing the job. This may sig-
nificantly reduce the exposure level over the to-
tal working period.
Identify additional safety measures to protect
the operator from the effects of vibration such
as: maintain the tool and the accessories, keep
the hands warm, organisation of work patterns.
Bosch Power Tools
Declaration of Conformity
We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
standardization documents: EN 60745 accord-
ing to the provisions of the directives
2004/108/EC, 2006/42/EC.
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider
2
,
Senior Vice President
Engineering
2
,
2
,
Robert Bosch GmbH, Power Tools Division
2
.
D-70745 Leinfelden-Echterdingen
Leinfelden, 19.11.2010
Assembly
Before any work on the machine itself, pull
the mains plug.
Auxiliary Handle
Operate your machine only with the auxilia-
ry handle 17.
Changing the position of the auxiliary handle
(see figure A)
The auxiliary handle 17 can be set to any posi-
tion for a secure and low-fatigue working pos-
ture.
– Turn the wing bolt for adjustment of the aux-
iliary handle 16 in anticlockwise direction
and set the auxiliary handle 17 to the re-
quired position. Then tighten the wing bolt
16 again in clockwise direction.
English | 23
Dr. Eckerhard Strötgen
Head of Product
Certification
1 609 929 T39 | (19.11.10)