Idiomas disponibles
Idiomas disponibles
ASSEMBLY OF BATCH BOWL PARTS
Prior to First Use:
• Clean and sanitize the motor base. Wash, rinse, and sanitize
the batch bowl, cover, food pusher, small pusher insert and
accessories.
• Place base on a counter or table near a 3-prong electrical
outlet. Position it so you look at the front of the unit and can see
the control panel. Do not plug in the cord until the processor is
completely assembled.
• Pick up the transparent batch bowl, holding it in both hands
with the handle toward you.
• Place the bowl on the base, fitting its central tube over the
motor shaft on the base and placing its handle slightly to the
left of back-center (at about a 7 o'clock position).
• Press the bowl down so the lower rim fits around the circular
platform. Turn the bowl counterclockwise as far as it will go. It
will lock into position with the tabs on the sides of the
platform.
Read this if assembling the batch bowl parts to use S-blade
or whipping disc assembly.
• Pick up the S-blade or whipping disc, noting the diagram on
the top of the plastic center. It matches the shape of the motor
shaft.
• Place the S-blade or whipping disc over the top of the motor
shaft, lining up the inside of the hub with the shaft. Press it
down firmly, rotating the center hub until the blade or disc
assembly is fully seated. It should easily drop into place. Push
firmly to lock and seal S-blade or whipping disc hub in place.
Be sure it is pushed down as far as it will go. If it is not all the
way down, it may become damaged and any liquid may leak.
Push only on the center section (plastic part); never touch the
cutting blade, as it is extremely sharp.
• Check to be sure the blade or disc is all the way down by
turning it back and forth while gently pushing it down. If
properly installed and fully seated, the lower blade will be
positioned just above the inside bottom of the bowl.
• If processing food with the S-blade or whipping disc, now is the
time to add the food or liquid to the batch bowl.
8
