Idiomas disponibles
Idiomas disponibles
Detergent and rinse aid ....
The detergent
Only use specific dishwasher detergents. The detergent
dispenser must be filled before each wash cycle begins
according to the instructions given in the "Wash cycle table".
The detergent dispenser is situated on the inside of the
appliance door.
Loading the detergent
To open lid "A", press button "B". The detergent should be
poured into the two containers "C" and "D" up to the rim.
After pouring in the detergent, replace the lid, pressing down
until it clicks.
Dishwasher detergent in tabs is now available on the market,
in which case you should place one tab into container "D"
and replace the lid.
B
D
A
To make sure the lid shuts properly, remove any
detergent residue from the edges of the container
before closing it.
Warning
Three-in-one dishwasher tablets are now available on the market, and combine the detergent, salt and rinse aid all in one. If the
water in your area is hard or very hard, we still recommend you pour extra salt into the relevant dispenser to prevent the
formation of white streaks on your dishes or on the appliance interior.
Add rinse aid to the corresponding container only if you are dissatisfied with the results on your dishes.
In any case, please read the manufacturer's instructions provided on the packet.
If you use only these products, it is normal for the salt and rinse aid indicator lights to flash permanently after a certain number
of cycles.
GB
All manuals and user guides at all-guides.com
C
Rinse Aid
This product makes dishes sparkle more as it improves their
drying. The rinse aid container is situated on the inside of
the door: It should be filled up when the low rinse aid
indicator light "F" flashes.
Loading the rinse aid
To open the dispenser, turn cap "C" anticlockwise and take
care when you pour in the rinse aid to avoid it overflowing.
You can adjust the amount of rinse aid used by the dishwasher,
by using a screwdriver to regulate the dosage adjuster "F"
you will find under lid "C". There are 6 possible settings; it is
normally set to 4.
Important:
Adjusting the rinse aid supply improves drying.
If drops of water remain on the dishes or spotting occurs,
turn the dosage adjuster to a higher setting. If, on the other
hand, the dishes have white streaks, then turn the dosage
adjuster down to a lower setting.
14
F
C
