Idiomas disponibles
Idiomas disponibles
FIGURE 8
INSTALLING THE ANGLE GUIDE
(see FIGURE 9)
1 . The angle guide is designed to fit on top of
the rip guide . Simply place angle guide onto
the top of the rip guide .
NOTE: The angle guide can be placed on either
the left or right side .
FIGURE 9
OPERATION
IMPORTANT: ALWAYS turn off the saw and
remove the plug from the outlet BEFORE
adding or removing accessories and making
adjustments .
THE SAW COULD RESULT IN ACCIDENTAL
STARTING CAUSING POSSIBLE SERIOUS
PERSONAL INJURY.
FAILURE TO UNPLUG
BEFORE STARTING THE SAW
1 . Make sure saw is unplugged .
2 . Remove the right cutting table and fill the
water reservoir to the top of the overflow
opening (see FIGURE 10) . Do not fill above
this level .
NOTE: ALWAYS keep enough water in the
reservoir when operating the saw . DO NOT let
the saw run dry .
3 . Re-attach and close right cutting table .
IMPORTANT: ALWAYS completely drain the
water reservoir and clean thoroughly after
each use.
FIGURE 10
TO START THE SAW
1 . Remove cord from compartment under the
saw and connect it to a GFCI (Ground Fault
Circuit Interrupter) protected outlet (see
FIGURE 11) .
3 .Push On/Off switch to the "On" position .
FIGURE 11
2 . Create "drip loop" in the cord (see
FIGURE 12) .
– 7 –
