Idiomas disponibles
Idiomas disponibles
2.1.
Rear panel view
PH 9310 (1K) | PH 9315 (1,5K) | PH 9320 (2K)
1.
Programmable outlets: connect to non-critical loads
3.
4.
AC input
|
Input circuit breaker
7.
connector (EPO)
|
USB communication port |
10. External battery connection (depends on the model)
2.2. Rack-Mounted the UPS
This UPS can be mounted in the 19" rack chassis. Please follow below steps to position this UPS.
Step 1
2.3. Setup the UPS
Step 1: Connect battery wires
• For safety consideration, the UPS is shipped out from factory without connecting battery wires. Before install the UPS,
please follow below steps to re-connect battery wires first.
Step 1
Remove front panel.
Step 2: UPS input connection
• Plug the UPS into a two-pole, three-wire, grounded receptacle only. Avoid using extension cords.
• For 208/220/230/240VAC models: The power cord is supplied in the UPS package.
Note: For Low voltage models: Check if the site wiring fault indicator lights up in LCD panel. It will be illuminated when
the UPS is plugged into an improperly wired utility power outlet (Refer to Troubleshooting section).
Step 3: UPS output connection
• For socket-type outputs, there two kinds of outputs: programmable outlets and general outlets. Please connect
noncritical devices to the programmable outlets and critical devices to the general outlets. During power failure, you may
extend the backup time to critical devices by setting shorter backup time for non-critical devices.
• For terminal-type input or outputs on the
a) Remove the small cover of the terminal block.
b) Suggest using AWG14 or 2.1mm2 power cords.
c) Upon completion of the wiring configuration, please check whether the wires are securely affixed.
d) Put the small cover back to the rear panel.
Segurança e harmonia
ININTERRUPTA
| 2.
Output receptacles: connect to mission-critical loads
5.
|
Network/Fax/Modem surge protection
8.
RS-232 communication port
Step 2
Step 2
Connect the AC input and
re-connect battery wires.
3K UPS
, please follow below steps for the wiring configuration:
2. Installation and setup
PH 9330 (3K)
6.
|
Emergency power off function
9.
|
SNMP intelligent slot
Step 3
Put the front panel back
PH 9310 | PH 9315 | PH 9320 | PH 9330
Uninterruptible Power Supply
EN
to the unit.
39
