Chicago Pneumatic CP3019-18 Instrucciones Originales página 5

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 9
Original instructions.
© Copyright 2010, Chicago Pneumatic
Tool Co. LLC
All rights reserved. Any unauthorized use or
copying of the contents or part thereof is prohibited.
This applies in particular to trademarks, model
denominations, part numbers and drawings. Use
only authorized parts. Any damage or malfunction
caused by the use of unauthorised parts is not
covered by Warranty or Product Liability.
INSTRUCTIONS
This product is designed for removing
material using abrasives. No other
use permitted. For professional use
only. Before servicing the power tool,
the supply of compressed air must be
disconnected or shut off.
When disposing of components,
lubricants, etc ... ensure that the relevant
safety procedures are carried out.
The tool is designed for a working
pressure of 6.3 bar (90 psig). The
compressed air must be clean. The
installation of a filter is recommended.
For maximum efficiency and performance,
comply with the specification of the air
hose (antistatic hose). (Refer to figure
no.1 for compressed air connection).
A: Ømini = 8mm (5/16")
B: 7 m max.
A
To obtain maximum efficiency from the
pneumatic tool, preserve its features
and avoid repeated repairs, a routine
inspection and repair programme
are recommended at least every 500
hours, the intervals between the various
inspections depending on the amount of
exertion on the power tool.
For dust extraction, please contact your
local sales.
5 / 29
EN
B
Check the free speed of the tool at regular
intervals and after each operation or
maintenance task. Remove the abrasive
to check the speed. The maximum
allowed speed shown on the tool must not
be exceeded and the vibration level must
not be excessive.
This tool is fitted with blades which can
operate without lubricated air. However,
a small amount of oil allows the tool to
provide full power and lengthens its life.
The use of dry air with no trace of oil may
reduce the life of blades.
Declaration of noise and vibration emission
(See page 29).
All values are current as of the date of this
publication. For the latest information please visit
www.cp.com.
These declared values were obtained by laboratory
type testing in accordance with the stated
standards and are suitable for comparison with the
declared values of other tools tested in accordance
with the same standards. These declared values
are not adequate for use in risk assessments and
values measured in individual work places may
be higher. The actual exposure values and risk of
harm experienced by an individual user are unique
and depend upon the way the user works, the
workpiece and the workstation design, as well upon
the exposure time and the physical condition of the
user.
We, Chicago Pneumatic, cannot be held liable for
the consequences of using the declared values,
instead of values reflecting the actual exposure,
in an individual risk assessment in a work place
situation over which we have no control.
This tool may cause hand-arm vibration syndrome
if its use is not adequately managed. An EU guide
to managing hand-arm vibration can be found at
http://www.pneurop.eu/uploads/documents/pdf/
PN3-02-NV_Declaration_info_sheet_0111.pdf
We recommend a programme of health surveillance
to detect early symptoms which may relate to
noise or vibration exposure, so that management
procedures can be modified to help prevent future
impairment.
2050541923
Issue no: 02
Series: C
02/2012
loading