Idiomas disponibles
Idiomas disponibles
Fig. C
7
To remove the bit, pull back the locking sleeve and pull the
bit out.
Inserting and Removing 17 mm HEX Bits
(Fig. D)
D25811
This tool uses 17 mm HEX accessories. We recommend to
use professional accessories only.
1. Clean and grease the bit shank.
2. Insert the bit shank into the tool holder
3. Push the bit further into the tool and turn it slightly until
it fits into the slots.
4. Ensure the bit is properly engaged.
NoTE: The bit needs to move several centimeters in and
out of the tool holder
7
Fig. D
To remove the bit, pull back the locking sleeve and pull the
bit out.
Bit Position Adjustment
Turn the mode selector to bit adjustment icon (Refer to
Mode Selection) to adjust the chisel to the desired position.
There are multiple positions to set the angle of the chisel.
NoTE: After finding the desired position, slightly maneuver
the chisel bit back and forth to ensure the chisel is
properly engaged.
OPERATION
WARNING: Always observe the safety instructions
and applicable regulations.
WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Proper Hand Position (Fig. E)
WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.
WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
8
7
.
when properly engaged.
8
7
Proper hand position requires one hand on the mounted
side handle, with the other hand on the main handle.
Fig. E
SHOCKS Active Vibration Control®
System
For best vibration control, hold the tool as described in
Proper Hand Position and apply just enough pressure so
the damping device on the main handle is approximately
mid stroke. The hammer only needs enough pressure to
engage the active vibration control. Applying too much
pressure will not make the tool chip faster and active
vibration control will not engage.
Mode Selection (Fig. F)
WARNING: Do not select the operating mode when
the tool is running. Tool must come to a complete stop
before activating the mode selector button or damage
to the tool may result.
Your tool is equipped with a mode selector dial
select the mode appropriate to desired operation.
symbol
Mode
Bit adjustment
hammering/
Chipping
To select a mode:
1. Depress the mode selector release button
2. Rotate the mode selector dial so that the arrow points to
the symbol corresponding for the desired mode.
Fig. F
5
NoTE: The arrow on the mode selector dial
pointing at a mode symbol at all times. There are no
operable positions in between.
ENglIsh
4
to
application
Chisel bit position
adjustment
Light chipping, chiseling
and demolition
5
.
4
must be
6
19
