Idiomas disponibles
Idiomas disponibles
Air Flow Mode
Activates Mode Selected
Rotate Outer Ring to
Access Desired Mode
Power On/Off
Chromatherapy Specific
Color (if provided)
Operating Instructions - Bath
NOTE: If the unit does not function properly, please refer to the "Troubleshooting" section.
Start the Unit
Fill the bath at least 4" (102 mm) above the top of the airjets.
Use your hand to test the water temperature before entering the bath.
Press the power icon on the user keypad to start the air system.
Adjust the air flow rate by pressing the up or down icon.
Select an Air Flow Mode
Rotate the outer ring on the keypad to select a mode.
Press the "OK" icon to activate the mode.
To turn a mode off, rotate the outer ring until the icon flashes green, then press the "OK" icon.
The icon will turn blue, indicating the mode is off.
Stop the Bath
Press the power icon to turn the air system off.
Press the power icon to turn the air system off.
Manual Purge Cycle (Optional)
NOTE: Follow these steps to manually purge residual water from the air system.
After stopping the air system and draining the bath, rotate the outer ring to the purge icon.
When the purge icon flashes blue, press the "OK" icon.
The purge icon flashes green as the manual purge begins. The air system operates at low speed to
blow residual water out of the air harness.
After 2 minutes, the air system stops automatically.
Care and Cleaning
For best results, keep the following in mind when caring for your KOHLER bath with airjets:
• Always test your cleaning solution on an inconspicuous area before applying to the entire surface.
• Wipe surfaces clean and rinse completely with water immediately after applying cleaner. Rinse and
dry any overspray that lands on nearby surfaces.
Kohler Co.
Zone 1
Zone 2
Zone 3
Chromatherapy Cycle (if provided)
17
Surge Mode
Increase Flow or Surge
Indicator Bar
Decrease Flow or Surge
Purge Mode
1204120-2-C
