Using The Shower Toilet - Invacare Aquatec Pure Bidet Manual Del Usuario

Aquatec® Pure Bidet
Overview of key functions on control panel
Pos. Key name
K CLEANSING/STOP
L POWER SAVING
M
LIGHT
N
LIGHT SENSOR
O POWER
P
LIGHT
Q AUTO
R SUPER

5.3 Using the shower toilet

Perform manual cleansing
A sensor is located inside the toilet seat, that is only
activated by skin contact.
18
Function
Device turns off
Power-saving mode activates
Night-light activates
When night-light function is
activated, bidet automatically
senses toilet light and night-light
LED switches on
Illuminates when unit is switched
on
Illuminates when night-light is
activated
Illuminates when automatic
power-saving mode is activated
Illuminates when super
power-saving mode is activated
1. If plugged-in, the device is turned on and the "POWER" LED O
illuminates on the control panel.
•
If the "POWER" LED does not illuminate, press any
button on the remote control (except HIGH/LOW or
FRONT/BACK buttons).
2. Set yourself centered on the toilet seat.
Press the CLEANSING/MOVE button C or BIDET/MOVE
3.
button D.
•
CLEANSING respectively BIDET-function is performed.
4. Press again CLEANSING/MOVE button or BIDET/MOVE button
during the cleansing process.
•
The cleansing nozzle moves back and forth. Nozzle stops
by pressing the button again.
Press STOP button B on the remote control.
5.
•
Shower procedure stops.
Press DRY button E on the remote control.
6.
•
Warm air dryer is activated. Dryer function stops by
pressing the "STOP" button.
Press CLEANSING/STOP button K and hold for more than 4
7.
seconds.
•
The device is turned off — All displays switch off on the
control panel.
CLEANSING/MOVE and BIDET/MOVE function operates
for 90 seconds. Hip bath function operates for 3 minutes.
DRY function operates for 3 minutes. The functions
are ending with an audible beep. Before and after each
operation, the self nozzle cleaning function runs and sanitizes
the nozzle head.
1590625-A