Idiomas disponibles
Idiomas disponibles
9.1
REPLACE THE BLADE
WARNING
Use only approved replacement blades.
WARNING
Wear heavy gloves or wind cloth around the blade when
you touch the blade.
1. Stop the machine.
2. Make sure that the blade(s) fully stop(s).
3. Remove the safety key and battery pack.
4. Turn the machine to its side.
5. Use a piece of wood (21) to prevent the movement of the
blade.
6. Remove the blade nut (18), the square washer (17), the
insulator washer (19) with a wrench or socket.
7. Remove the blade (20).
8. Install the new blade. Position the blade with the cutting
edges toward the ground.
9. Put in the blade nut, the square washer and the insulator
washer and tighten the blade nut CLOCKWISE.
9.2
STORE THE MACHINE
•
Clean the machine before storage.
English
•
Make sure the motor is not hot when you put the machine
into storage.
•
Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
•
Replace the damaged parts.
•
Tighten the bolts.
•
Speak to a person of an approved service center.
•
Store the machine in a dry area.
•
Make sure that children cannot come near the machine.
You may lower the handle(s) before you put the machine into
the storage.
1. Fully loosen the handle fasteners on the sides of the
handle(s).
2. Fold away the handle(s).
3. Do not pinch or trap the cables.
10
TROUBLESHOOTING
Problem
The handle is not
in position.
The machine does
not start.
The machine cuts
grass unevenly.
The machine does
not mulch correct-
ly.
The machine is
hard to push.
11
Possible cause
Solution
The bolts are not
Adjust the height
engaged correctly.
of the handle and
make sure that the
knobs and bolts
are aligned cor-
rectly.
The battery ca-
Charge the battery
pacity is low.
pack.
The bail switch is
Replace the bail
defective.
switch.
The safety key is
Put in the safety
not put in.
key.
The lawn is rough. Examine the mow-
ing area.
The blade height is
Adjust the blade/
not set correctly.
cutting height to a
higher position.
Wet grass clip-
Wait until the
pings attach to the
grass dries before
deck.
mowing.
The mulch plug is
Install the mulch
missing.
plug.
The grass is too
Increase the blade/
tall, or the blade
cutting height.
height is too low.
The grass catcher
Empty the grass
and the blade
clippings from the
drags in thick
grass catcher.
grass.
EN
