Idiomas disponibles
Idiomas disponibles
Anleitung SO 12-M
7. How to charge Einhell power
stations
Proceed as follows to charge Einhell power stations:
Fit the connecting cable as described above.
Set the On/Off/Cha switch of the power station to
„On".
Insert the cigarette lighter plug in the 12V socket
of the power station.
Charging time depends on the actual state of the
battery as explained above.
8. Further notes
The protective diodes integrated in the connecting
cable prevent a reversal of current back into the
module. Without these diodes current reversal would
occur at night and in periods of poor sunlight.
Caution! Cutting the cable destroys this protective
function. The built-in overcharge cut-out prevents
overloading of the battery, i.e. there is no need to
disconnect the solar module from the battery even
when the necessary charging time is exceeded.
When the battery voltage reaches 14.1V, the
overcharge cut-out will interrupt the charge until the
voltage drops again below 14.1V.
9. Ordering replacement parts
If you ever need a replacement part, please quote
the following details:
Type of unit
Article number of the unit
ID number of the unit
Replacement part number of the item required
07.11.2001 15:19 Uhr
Seite 5
GB
5
