Idiomas disponibles
Idiomas disponibles
NS-RTV32 32-inch MTS Stereo Color TV
Setting up your television
Connecting your television to AC power
Use the AC polarized cord provided for operation
on AC. Insert the AC plug into a standard 120V
60Hz polarized AC outlet.
Wider hole
and blade
Polarized AC plug (one
blade is wider than the
other.)
Notes
• Never connect the AC plug to other
than the specified voltage (120V
60 Hz). Use the attached power cord
only.
• If the polarized AC cord does not fit into
a non-polarized AC outlet, do not file or
cut the blade. It is your responsibility to
have an electrician replace the
obsolete outlet.
• If you cause a static discharge when
touching the television and the
television fails to work, unplug the
television from the AC outlet, then plug
it back in. The television should work
normally.
Installing batteries in the remote control
Before using the remote control, you must install
batteries. Use two AAA size batteries (not
supplied). The batteries may last about one year
depending on how much the remote control is
used. For best performance, we recommend the
batteries should be replaced on a yearly basis,
or when the remote operation becomes erratic.
Do not mix old and new batteries or different
types.
To install batteries in the remote control:
1 Open the battery compartment cover.
AC outlet
Battery precautions
Connecting to an antenna
Combination VHF/UHF antenna (single 75 ohm
cable or 300 ohm twin-lead wire)
www.insignia-products.com
2 Install two AAA batteries (not supplied).
3 Replace the battery compartment cover.
Follow these precautions when using batteries in
this remote control:
•
Use only the size and type of batteries
specified.
•
Make sure to follow the correct polarity when
installing the batteries as indicated in the
battery compartment. Reversed batteries
may damage the device.
•
Do not mix different types of batteries
together (such as alkaline and carbon-zinc)
or old batteries with fresh ones.
•
If the remote is not to be used for a long
period of time, remove the batteries to
prevent damage or injury from possible
battery leakage.
•
Do not try to recharge batteries that are not
intended to be recharged. These batteries
can overheat and rupture (follow battery
manufacturer's directions).
If you are using an indoor or outdoor antenna,
follow the instructions that correspond to your
antenna system. If you are using a cable
television service, see "Connecting to cable
television" on page 6.
75 ohm
coaxial
cable
RF IN jack
1 Connect the 75 ohm cable from the
combination VHF/UHF antenna to the RF IN
jack.
2 If your combination VHF/UHF antenna has a
300 ohm twin-lead wire, you may need to use
a 300-75 ohm matching transformer.
RF IN jack
300-75 ohm
matching
transformer
5
