Southland SRTT196E Manual Del Operador página 15

Ocultar thumbs Ver también para SRTT196E:
Idiomas disponibles

Idiomas disponibles

Operation
(Continued)
• Save all instructions
H
Adjustments
WARNING
Engine should be off before
adjusting any controls.
Extreme caution should be used
when operating tiller in the
reverse direction.
WHEEL LOCK PINS
(See Figures 2 on pg. 8 and 11)
Place wheels in tilling position.
1. Remove lock pin. Align hole in axle with hole in wheel hub.
2. Insert lock pin through holes, fold lock pin ring to secure
pin to axle.
3. Firmly lock wheel and axle together before tilling.
4. Repeat for other wheel.
WARNING
Always have both wheel lock pins in or out. Do not operate
tiller with only one wheel locked.
To place wheels in free-wheel position.
1. Remove lock pin. Slide wheel inward toward machine.
2. Insert pin in axle only, fold lock pin ring to secure pin to axle.
3. Wheel should turn freely on axle.
HANDLEBAR HEIGHT ADJUSTMENT
Adjust handlebar height.
The ideal height of the handlebar varies with operator
height and the depth of tilling.
1. Unscrew nuts and remove top bolts on each side.
2. Loosen the lower bolts. Do not remove.
3. Align handlebar to desired holes on the lower
handlebar mount.
4. Install bolts and nuts. Retighten all four bolts securely.
DEPTH REGULATOR
(See Figure 3 on pg. 8)
Tilling depth is controlled by the height of the
depth regulator. To adjust tilling depth:
1. Remove pin.
2. Raise the depth regulator to position tines at chosen
tilling depth.
3. Align hole in depth regulator with hole in depth regulator
bracket and replace pin.
Depth Regulator Down = Shallower tilling.
Place the pin in the top hole of the depth regulator for
shallowest tilling.
Depth Regulator Up = Deeper tilling.
Place the pin in the bottom hole of the depth regulator for
deepest tilling.
Questions? Call Toll Free at 1-800-737-2112
(See Figure 4 on pg. 9)
14
Wheel lock pin in free-wheel position
(axle holes only)
WARNING
Do not adjust tilling depth unless drive safety control levers are
released to neutral position.
Always set the depth regulator in the transport position
before starting engine, that is, place the detent pin in the
highest hole of the depth regulator.
Copyright © 2016 MAT Engine Technologies, LLC
FRONT
Figure 11
loading

Este manual también es adecuado para:

Srtt196