Idiomas disponibles
Idiomas disponibles
■ Add 1 KRUPS (w) spoonful of ground coffee per cup. Do not exceed 14 spoons (2.5 ounces). Fig. 10.
■ If ground coffee has accidentally been poured into the water tank, please do not run the cycle; instead
clean the water tank. The ground coffee could plug the water circuit.
■ Close the lid (b).
■ Press the ON OFF button (Fig. 11) to turn on the coffee maker and then press BREW
cycle. When the coffee maker begins the brew cycle, the BREW button will light, and the machine will beep
once. Fig. 12.
■ When the brew cycle ends, the coffee maker beeps 3 times, the 'keep warm' cycle automatically begins,
and the screen will display the time remaining before the 'keep warm' cycle ends. The BREW button
flashes slowly.
■ After the default keep warm time of 4 hours your coffee maker beeps 3 times and the BREW button (k)
switches off.
■ At any time during the brew cycle, you may turn off the coffee maker by pressing the BREW button (k) or
ON OFF button. The light on the BREW button will also go out. It beeps 3 times prior to turning off.
Even if the brew cycle has ended, there is still hot liquid in the filter. Wait a few minutes for the rest of the
liquid to flow into the carafe before removing the filter.
Note :
- The amount of coffee in the carafe at the end of the cycle is less than the amount of water poured into the
water tank, since the ground coffee and the filter absorb about 10% of it.
- The water tank is equipped with an overflow outlet at the rear of the appliance. If you add too much water,
excess water will leak from this opening.
- Clean the permanent filter in between each use, or use a paper filter.
CAUTION:
- To avoid overflowing, the carafe should be properly placed on the warming plate of the coffee
maker, otherwise the hot water or hot coffee may overflow.
- The coffee maker becomes very hot during the brew cycle. Handle it carefully.
6. OTHER FEATURES
6A – AUTO START FUNCTION (AUTO)
Programming the auto-start settings.
■ Your appliance is equipped with one auto-start program.
■ Check whether the clock is set to the right time. If not, follow the instructions in the SETTING THE CLOCK
section.
■ Press the AUTO button
■ Set the time by pressing the HR button
time will be displayed. It will be automatically set after about five seconds. The time is displayed. Fig. 14 and
15.
Activate a delayed start-up when the time is already pre-set.
■ Select AUTO by pressing the AUTO button
■ To cancel the AUTO setting, press the AUTO button
6B – REGULAR OR BOLD
■ This feature allows you to adjust the coffee intensity.
■ The BOLD feature increases the brew time of the cycle for a stronger coffee.
■ Press the BOLD button to select the intensity of your coffee. Fig. 16.
■ The REG or BOLD icon appears on screen.
■ The feature is stored in the memory for subsequent cycles.
6C – 1- 4 CUPS
■ To activate this feature, press the 1-4 button (n) before starting the cycle. Fig. 17.
■ The 1-4 icon will appear on the display.
■ This feature is especially designed for making small amounts of coffee, with optimal aroma and flavor.
10
(p)
. An AUTO icon displays on screen. Fig. 13.
(r)
to set the hours and the MIN button
(p)
.
(p)
ONE time.
(k)
to start the
(s)
to set the minutes. The
(k)
