Idiomas disponibles
Idiomas disponibles
Assembly & Set-Up
Contents of Carton
•
One Snow Thrower
•
One Snow Thrower Operator's
Manual
•
One Engine Manual
Assembly
Handle
1.
Place the shift lever in the Forward-6 position.
2.
Observe the lower rear area of the snow thrower to be sure
both cables are aligned with roller guides before pivoting
the handle upward. See Fig. 3-1.
Figure 3-1
NOTE: Make certain the cables are seated properly in the
roller guides. See Fig. 3-2.
3.
Secure the handle by tightening the plastic knob located
on both the left and right sides of the handle. Remove
and discard any rubber bands, if present. They are for
packaging purposes only.
•
Two Replacement Auger Shear Pins
•
One Product Registration Card
Chute Assembly (Model 2410)
1.
Position the chute assembly over the base. See Fig. 3-3.
•
One Chute Assembly (Model 2410)
•
One Chute Control Rod
(Models 2620, 2840 and 3090XP)
Figure 3-2
Figure 3-3
3
7
