Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Assembly & Set-Up
Contents of Carton
•
One Snow Thrower
•
One Chute Assembly
•
One Electric Starter Cord (If equip.)
NOTE: This Operator's Manual covers several models. Snow
thrower features may vary by model. Not all features in this
manual are applicable to all snow thrower models and the snow
thrower depicted may differ from yours.
NOTE: All references to the left or right side of the snow thrower
are from the operator's position. Any exceptions will be noted.
Tools Required
•
• One 5/16-inch wrench (or adjustable wrench)
•
• One 1/2-inch wrench (or adjustable wrench)
Assembly
Positioning the Upper Handle
1.
Remove the wing knob and carriage bolt from the top
of the lower handle. See Figure 3-1. It is not necessary to
remove the shoulder screw and flange lock nut below the
wing knob and carriage bolt.
Wing Knob
Figure 3-1
•
One 20 oz. Bottle 5W-30 Oil
•
One Chute Rotation Control (If equip.)
•
One Snow Thrower Operator's Manual •
Carriage Bolts
Wing Knob
•
Two Ignition Keys
•
One Set of Drift Cutters (If equip.)
One Engine Operator's Manual
2.
Pivot the upper handle into the operating position. Be sure
not to pinch any of the cables in the process. See Figure 3-2.
Figure 3-2
Installing the Chute
1.
Remove the hex washer screws in the chute base. See
Figure 3-3.
Figure 3-3
3
7
Tabla de contenido
Solución de problemas
