Idiomas disponibles
Idiomas disponibles
Protections against other causes
Protection system is also designed for other causes that could
damage the tool and allows the tool to stop automatically.
Take all the following steps to clear the causes, when the tool
has been brought to a temporary halt or stop in operation.
1.
Turn the tool off, and then turn it on again to restart.
2.
Charge the battery(ies) or replace it/them with
recharged battery(ies).
3.
Let the machine and battery(ies) cool down.
If no improvement can be found by restoring protection
system, then contact your local Makita Service Center.
Power switch action
WARNING:
For your safety, this tool is equipped
with lever which prevents the tool from unintended
starting. NEVER use the tool if it runs when you
simply pull the switch triggers without pressing the
lever. Return the tool to our authorized service center
for proper repairs BEFORE further usage.
WARNING:
NEVER tape down or defeat pur-
pose and function of the lever.
WARNING:
Before installing the battery car-
tridge on the tool, always check to see that the
switch triggers and lever actuate properly and return
to the "OFF" position when released. Operating a tool
with a switch that does not actuate properly can lead to
loss of control and serious personal injury.
CAUTION:
Never put your finger on the
switch triggers when carrying. The tool may start
unintentionally and cause injury.
NOTICE:
Do not pull the switch trigger hard without
pressing the lever. This can cause switch breakage.
Press the main power button to turn on the tool. To turn off the tool,
press and hold the main power button until the speed indicators go off.
1
Fig.4
► 1 . Main power button
NOTE: The caution lamp brinks if the switch trigger
is pulled under unoperatable conditions. The caution
lamp blinks if you turn on the main power switch while
holding down the lever and the switch trigger.
NOTE: This tool employs the auto power-off function. To
avoid unintentional start up, the main power switch will auto-
matically shut down when the switch trigger is not pulled for
a certain period after the main power switch is turned on.
To prevent the switch trigger from being accidentally
pulled, the lever is provided. To start the tool, pull the
front switch trigger, and then pull the rear switch trigger
while pressing the lever. When you release either of the
switch triggers, the tool stops.
1
2
Fig.5
► 1 . Lever 2. Rear switch trigger 3. Front switch
trigger
Speed adjusting
You can adjust the tool speed by pressing the main
power button. Each time you press the main power
button, the level of speed changes.
1
2
Fig.6
► 1 . Speed indicator 2. Main power button
Speed indicator
8 ENGLISH
3
Mode
Stroke speed
High
5,000 /min
Medium
3,600 /min
Low
2,000 /min
