Idiomas disponibles
Idiomas disponibles
25
• If the brewing system is not inserted correctly
until hearing the click, the two red buttons have
not opened out properly and the service door
will not close, and the machine will not operate.
The
light will start flashing if this is the case.
• If it is difficult to insert the brewing system,
squeeze it into size by vigorously pressing from
above and below at the same time (Figure 28).
• If it is still difficult to insert the brewing system,
Figure 27
leave it out of the machine, close the service
door, unplug the machine from the power outlet and then plug it in
again. Wait for all the lights to go off, then open
the door and replace the brewing system.
• Replace the cup support and used coffee
container.
• Close the service door.
Figure 28
15.7 Decalcification:
• Due to the continuous heating of the water
used to make espresso / coffee, over time it is normal for the tubing
inside the machine to fill with lime scale. When the
lights starts
flashing, it is time to decalcify the machine.
• When the
light switches on, the machine still can be used to
prepare espresso / coffee. But for the best tasting espresso / coffee, it
is recommended that you decalcify the machine when the
light
starts to flash.
• The machine must be plugged in and turned on during the
decalcification process.
Proceed as follows:
• Empty the tank and pour in the contents of one bottle 5 oz. (125 ml)
of DURGOL descaler plus one liter of water. For subsequent descaling
operations, descaling solution can be purchased from authorized
technical service centers.
NB: Make sure splashes of descaler do not fall onto surfaces sensitive to
acid such as marble, limestone and glaze.
• Place a container (with a minimum capacity of 60 oz. / 1.5 liters)
under the milk frother (Figure 5).
• Turn the machine on by pressing the power button (Figure 6).
•Wait for the green
and
indicator lights to illuminate steadily
(not flashing).
