Makita DCU603 Manual De Instrucciones página 15

Removing the bucket
To remove the bucket, perform the installation proce-
dure in reverse.
Installing or removing the carrier
Optional accessory
Installing the carrier
1. Take out the carrier from the box, and attach the
side rails and front rail to the base frame.
Fig.19
2.
Tighten 6 thumb nuts together with springs and
washers to fix the rails.
Fig.20
► 1. Thumb nut 2. Spring 3. Washer
3. Place the carrier on the dump unit.
Insert the bolt from the top. Attach the flat washer and
spring washer in order to the bolt, and then tighten the
nut from the bottom. Tighten the rest of the bolts and
nuts in the same way.
Fig.21
► 1. Bolt 2. Flat washer 3. Spring washer 4. Nut
1
Removing the carrier
2
To remove the carrier, perform the installation proce-
3
dure in reverse.
Installing or removing the flat
bucket
Optional accessory
Installing the flat bucket
1.
Take out the flat bucket and holding frames from
the box.
Fig.22
► 1. Flat bucket 2. Holding frame
15 ENGLISH
1
2
3
4
1
2