Idiomas disponibles
Idiomas disponibles
STARTING THE AIR CONDITIONER cont.
1. Carefully remove the clear plastic film from the control panel.
2. r P ess POWER once to turn on the air conditioner.
NOTE:
W
h
e
n
the air conditioner is first plugged in, the LED display will show "88" for 3 seconds.
After the air conditioner is turned on for the first time, the display will show the
temperature 72 F and the fan is automatically set to Low speed and the Mode indicator will
show ENERGY SAVE.
NOTE: To switch the temperature display between Fahrenheit (F) and Celsius(C), the air
conditioner must be plugged in, and turned ON. On the control panel on the front of
the AC, press the UP and DOWN button at the same time and hold for 3 seconds. The
change cannot be done using the remote control.
3. Select Mode. Refer to "Mode."
4. Select Speed. Refer to "Speed."
5. Set Timer. Refer to "Temp/Time"
6. Reset the filter. Refer to "Filter Reset"
MODE
1. Press mode until you see the indicator light come on next to the desired setting.
2. Choose Fan,
Energy Save,
FAN― Only the fan runs. Press SPEED to select High, Med or Low fan speed. The display shows
the current room temperature.
ENERGY SAVE― In this mode the fan runs only when cooling is needed. The fan will run for 3
minute after the compressor shuts off. The fan then cycles on for 2 minutes
at 10 minute intervals until the temperature in the room is above the set
temperature. The compressor then turns back on.
COOL― Cools the room. Press SPEED to select High,Med , Low or Auto Cool fan speed. Press the
TEMP/TIME up or down arrow button to adjust the temperature.
DEHUM―
i A
s d
in removing humidity from the room. This setting will NOT cool the room.
NOTE:
D
e
h
u
m
mode cannot be used to cool the room.
•
°
Cool
or Dehum.
USING YOUR AIR CONDITIONER
ENGLISH
PAGE 15
