Idiomas disponibles
Idiomas disponibles
Your Vac has a convenient area to store
your power cord and Vac hose.
Wrap the power cord around the top of
the handle on the Vac and attach the end
of the plug to the cord.
Wrap the hose around the Vac as shown
and place the small swivel end inside the
larger one.
Filter
NOTE: This Filter is made of high quality
paper designed to stop very small
particles of dust. The Filter can be used
for dry pick up or limited wet pick up.
Handle the Filter carefully when removing
or installing. Creases in the Filter pleats
may occur from installation but creases
will not affect the performance of the
Filter.
Cleaning A Dry Filter
NOTE: For best cleaning results due to
accumulated dust, clean the Filter in an
open area. Cleaning SHOULD be done
outdoors and not in the living quarters.
1. Light cleaning of some dry debris from
the Filter can be accomplished without
removing the Filter from the Vac.
Simply slap your hand on top of the
handle while the Vac is turned off.
2. Remove Filter from Vac. Gently tap the
Filter against the inside wall of your
dust drum and the debris will loosen
and fall.
3. For thorough cleaning of a dry Filter
with fine dust (no debris) you may run
water through it as described under
"Cleaning A Wet Filter" Section.
CORD & HOSE STORAGE
MAINTENANCE
Car Nozzle
Compartment
Handle
Cleaning A Wet Filter
After Filter is removed, run water through
the Filter from a hose or spigot. Take care
that water pressure from the hose is not
strong enough to damage Filter.
IMPORTANT: After cleaning, check the
Filter for tears or small holes. Do not use
a Filter with holes or tears in it. Even a
small hole can cause a lot of dust to
come out of your Vac. Replace it
immediately.
Allow the Filter to dry before reinstalling
and storing the Vac.
9
Hose
Storage
Area
Power
Cord
