Idiomas disponibles
Idiomas disponibles
Using the water dispenser.
4
Loading the Dispenser and Start Up
Sanitize the dispenser water tanks prior to
installing a full bottle of water for the first time
(see "Cleaning and Sanitizing the Water Tanks").
IMPORTANT: Make sure the dispenser is unplugged
with both the hot and cold power switches (on the
back of the dispenser) set to the O (off) position.
Before placing the water bottle on the dispenser,
wash hands and wipe the top of the bottle with a
clean cloth. Avoid touching the part of the bottle
that will be in contact with the water dispenser.
Make sure the water level in the top of the
dispenser is low enough to allow for proper
bottle installation. Failure to do so may cause
the dispenser to overflow.
1. Peel the label from the top cover of the
bottle (if present). Do not remove the entire
bottle cap.
Features and Parts List
Bottle Support Collar—White (WS28X10049)
Separator (WS28X10013)
Cold Water Tank
Hot (Red) and Cold (Blue) Power Switch (back of dispenser).
The Cold (Blue) power switch also turns on the chiller
compartment (model GXCF25HWW only).
Indicator Lights. The green light will be lit when the dispenser is
plugged in. The red and blue lights will cycle on and off while
the dispenser heats and cools the water. Compressor start is
delayed up to 3 minutes.
Hot
, Room Temperature
Dispenser Drip Tray (WS28X10026) and Grille (WS28X10027)
Compartment Drip Tray (WS29X10029) (model GXCF25HWW only)
Storage Compartment (model GXCF15HWW only). Do not use to store
food requiring refrigeration. The compartment is not
refrigerated.
Chiller Compartment (model GXCF25HWW only). The compartment
is intended solely for use in chilling canned and boxed beverages,
and packaged nonperishables.
Compartment Shelf (WS28X10028)
Drainage Cap (WS01X10008)
Silicon Stopper (WS01X10007)
2. Place the bottle on top of the dispenser as
shown, aligning the dispensing valve probe
to the center of the water bottle cap. Press
down until the probe penetrates the bottle
cap, allowing the bottle to rest on the
support collar.
3. IMPORTANT: Press both dispense buttons until
water runs from both taps.
4. Plug in the dispenser.
5. Set the COLD and HOT power switches
(located on the top left rear of the dispenser)
to the I (on) position.
6. Allow 30 minutes for water to reach hot and
cold temperatures.
Contact a local water bottle distributor to purchase
water bottles.
, Cold
Water Dispenser Buttons
