Idiomas disponibles
Idiomas disponibles
4. PANELS MOUNTING
4.3 Panels dimensions
(7
Example:
83 7/8" niche height
35 3/8" niche width
4" toe kick height
1/8" gap desired all around
Door panel:
Width: 35 1/4"
Height: 54 3/4"
Drawer panel:
Width: 35 1/4"
Height: 83 7/8" - 1/8" - 54 3/4" - 1/8"
- 4" = 24 7/8"
If you want a 6" toe kick height
then your bottom drawer panel
115 (4 ½")
height would be 22 7/8"
4.4 Mounting the handles on Integrated
units
Handles will have to be mounted on the panels be-
fore they are applied to the fridge. For overlay panel
mounting, remove the screw connecting the stand-
offs to the handle bar.
The overlay screw will pass through the overlay pa-
nel, the stand-off and into the handle bar.
Operate as follows:
>
Drill two holes of 5 mm (1/4 ") on the rear side pa-
nels, insert the supplied screws to the distance indica-
ted in the the table below. To center the vertical handle
(code HV) to the center of the door, split into two the
height of the panel and make a hole at -450 mm (-17
3/4") and one at +450 mm (+17 3/4")
>
Place the handle on top of the holes and insert
the screws through the panel and into the handle
support
[ 2
].
12
)
135
(5
)
[ 1
].
www.universal.bertazzoni.com
3,2 (1/8")
1
2
A
