Idiomas disponibles
Idiomas disponibles
SHARPENING THE CUTTERS
See Figures 38 - 41.
Be careful to file all cutters to the specified angles
and to the same length, as fast cutting can only be
obtained when all cutters are uniform.
WARNING:
Before performing any maintenance, make sure
the tool is unplugged from the power supply.
Failure to comply could result in accidental
starting and possible serious personal injury.
WARNING:
The saw chain is very sharp. Always wear pro-
tective gloves when performing maintenance to
the chain to prevent serious personal injury.
Tension the chain prior to sharpening. Refer to
Adjusting The Chain Tension in the mainte-
nance section.
Use a 5/32 in. diameter round file and holder.
Do all of your filing at the midpoint of the bar.
Keep the file level with the top plate of the tooth.
Do not let the file dip or rock.
Using light but firm pressure. Stroke towards
the front corner of the tooth.
Lift the file away from the steel on each return
stroke.
Put a few firm strokes on every tooth. File all left
hand cutters in one direction. Then move to the
other side and file the right hand cutters in the
opposite direction.
Remove filings from the file with a wire brush.
NOTICE:
A dull or improperly sharpened chain can cause
excessive motor speed during cutting, which
may result in severe motor damage.
WARNING:
Improper chain sharpening increases the poten-
tial of kickback, which could result in serious
personal injury.
MAINTENANCE
TOP PLATE
RIVET
HOLE
RIGHT HAND
Failure to replace or repair a damaged chain
could cause serious injury.
Page 30 — English
CUTTING
CORNER
HEEL
GULLET
LEFT HAND
CUTTERS
CUTTERS
WARNING:
SIDE PLATE
DEPTH GAUGE
TOE
Fig. 38
Fig. 39
Fig. 40
Fig. 41
