Idiomas disponibles
Idiomas disponibles
DANGER:
Never cut near power lines, electric cords, or
other electric sources. If bar and chain jams
on any electrical cord or line, DO NOT TOUCH
THE BAR OR CHAIN! THEY CAN BECOME
ELECTRICALLY LIVE AND VERY DANGEROUS.
Continue to hold the chain saw by the insulated
rear handle or lay it down and away from you in
a safe manner. Disconnect the electrical service
to the damaged line or cord before attempting
to free the bar and chain from the line or cord.
Contact with the bar, chain, other conductive
parts of the chain saw, or live electric cords or
lines will result in death by electrocution, electric
shock, or serious personal injury.
WARNING:
Do not allow familiarity with this product to
make you careless. Remember that a careless
fraction of a second is sufficient to inflict seri-
ous injury.
WARNING:
Always wear eye protection with side shields
marked to comply with ANSI Z87.1, along with
hearing and head protection. Failure to do so
could result in objects being thrown into your
eyes resulting in possible serious injury.
WARNING:
Do not use any attachments or accessories
not recommended by the manufacturer of this
product. The use of attachments or accessories
not recommended can result in serious personal
injury.
OPERATION
QUICK VIEW
OIL INDICATOR
WARNING:
Never fell a tree or cut a log or limb that has a
diameter greater that the length of the guide
bar. Only properly trained professionals should
perform these cuts. Performing these types of
cuts can cause an accident and result in death
or serious personal injury.
APPLICATIONS
You may use this product for the purposes listed
below:
Basic limbing, felling, and woodcutting
Removing buttress roots
ADDING BAR AND CHAIN LUBRICANT
See Figure 7.
Use HOMELITE Bar and Chain Lubricant. It is
designed for chains and chain oilers, and is for-
mulated to perform over a wide temperature range
with no dilution required.
NOTE: Chain saw comes from the factory with
no bar and chain oil added. Level should also be
checked after every 20 minutes of use and refilled
as needed.
Disconnect chain saw from power supply.
Remove oil cap.
Carefully pour the bar and chain oil into the tank.
Wipe off excess oil.
Check and fill the oil tank when quick view oil
indicator is below the second to last indicator
line.
Page 17 — English
OIL RESERVOIR
CAP
Fig. 7
