Introduction; Assembly And Installation; Electrical Connections; Start-Up - Velp Scientifica RX3 Manual De Instrucciones

Tabla de contenido

1. Introduction

Mixing by spinning can be carried out quickly and safely by placing the tube containing the sample on the mixing cup head.
Mixing starts when the test-tube tube is placed on the mixing cup head.
The press-on fitting means that the mixing cup head can easily be replaced by A00000016.

2. Assembly and installation

Check the integrity of the unit after unpacking. The box includes:
RX3 Vortex Mixer with mixing cup head
EU adapter plug

2.1 Electrical connections

After having unpacked the instrument, place the unit on the laboratory bench.
Before connecting the instrument to the power supply, make sure that the values on the rating plate correspond to those of
the power supply. Connect the unit to the power supply using the transformer supplied.
Ensure that the socket and the relative cut-off device conform to current safety norms and are easy to reach.
NOTE: in case of black-out, the device will not automatically restart after the break and reconnect the power supply.

2.2 Start-up

Check that the mixing cup head is correctly positioned. Use the on-off switch on the front of the unit to turn the unit on
(position "ON"). Mixing starts automatically when the tube is lightly pressed down on the mixing cup head.

2.3 Information about construction materials

Housing
Paint / Frontal control panel
Cup head

3. Maintenance

No routine or extraordinary maintenance is necessary apart from periodically cleaning the unit as described in this manual.
In compliance with the product guarantee law, repairs to our units must be carried out in our factory, unless previously
agreed otherwise with local distributors. To replace the cup head, pull it upwards and off. The other push-fit accessories can
then be inserted. The instrument must be transported in its original packaging and any indications present on the original
packaging must be followed (e.g. palletized).
It is the responsibility of the user, to properly decontaminate the unit in case of hazardous substances remaining on the
surface or interior of the device. If in doubt about the compatibility of a cleaning or decontamination product, contact the
manufacturer or distributor.

3.1 Cleaning

Disconnect the unit from the power supply and use a cloth dampened with an non-inflammable non-aggressive detergent.
Zinc alloy/Polymer
PET
SEBS
Power supply 100-240V/12V no plug
Instruction manual
Feet
Platform
Foamed part for platforms
7
EN
PVC
PP
PE
Tabla de contenido
loading

Este manual también es adecuado para:

F202a0171

Tabla de contenido