GreenWorks G40PFS Manual Del Operario página 6

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 17
1. Fit the extension pole between the pole saw handle
and the pole saw head to achieve the maximum
length.
2. Slide the collars upwards.
3. Turn the collars clockwise to tight them.
WARNING
Periodically check the tightness of the connection
of the collars.
3.5
USE THE SHOULDER STRAP
Figure 4
1. Attach the carabiner to the carrying ring on the pole.
2. Put on the shoulder strap.
3. Adjust the length of the strap so that the carabiner is
about the width of a hand below your right hip.
3.6
CUTTING PREPARATION
Figure 4
Before you start to cut, make sure that
Wear heavy gloves for maximum grip and
protection.
Maintain a proper grip on the machine during
operation.
Use your right hand grip on the rear handle while
your left hand grip on the pole shaft.
Keep your body to the left of the chain line.
Never use a left-handed (cross-handed) grip, or
any stance that places your body or arm across
the chain line.
Never stand directly under the limb you are cutting.
Periodically examine the tightness of the collars
during operation.
3.7
INSTALL THE BATTERY PACK
Figure 5
WARNING
If the battery pack or charger is damaged, replace
the battery pack or the charger.
Stop the machine and wait until the motor stops
before you install or remove the battery pack.
Read, know, and follow the instructions in the
battery and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2. Push the battery pack into the battery compartment
until the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
English
3.8
REMOVE THE BATTERY PACK
Figure 5
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
4
OPERATION
Remove the battery pack and keep hands clear of the
lock out button when you move the machine.
Examine the chain tension before each use.
4.1
EXAMINE THE CHAIN
LUBRICATION
Do not use the machine without sufficient chain
lubrication.
Figure 6
1. Examine the lubricant level of the machine from the
oil indicator.
2. Add more lubricant if it is necessary.
4.2
START THE MACHINE
Figure 7
1. Install the battery pack into the machine.
2. Press the safety lock button.
3. Pull the small safety lock button upward with your
thumb.
4. Press the trigger.
4.3
STOP THE MACHINE
Figure 7.
1. Release the trigger to stop the machine.
4.4
DELIMBING A TREE
Figure 8
Make sure that there is nothing or nobody in the area
where the branches fall.
Stand opposite the branch you will cut.
Start to cut the higher branches.
Then cut the lower branches.
Cut downwards to prevent the bar from jamming.
5
NOTE
IMPORTANT
NOTE
WARNING
EN
loading

Este manual también es adecuado para:

Psf303