Idiomas disponibles
Idiomas disponibles
7
TAPE
ASES/COPY
TAPE I/II
46
En
All manuals and user guides at all-guides.com
REC/STOP
Recording Cassette Tapes
Copying tapes
Here's how to copy a tape from deck I to deck II.
1 Press TAPE I/II.
2 Load the source tape into deck I.
Recording starts in the 3 direction, so take care over which way
you load the tape.
3 Prepare tape deck II for recording.
Load a blank cassette and wind on past the leader.
XR-A790 only: Switch Dolby NR on or off as required—for best
results, switch on if the tape you're recording was recorded using
Dolby NR.
Note: It's not possible to switch Dolby NR on and off
independently for each deck.
4 Press ASES/COPY to start recording.
Recording starts in the 3 direction and continues onto the other
side, unless the erase-protect tab is broken on the cassette in deck
II.
5 If you want to stop recording before the end of the
tape is reached, press 7.
Improving AM tape recordings
• XR-A790 model only.
Recording AM broadcasts on cassette tape can result in noisy
recordings. If you experience this, change the beat cut function:
1 Switch the system into standby.
2 Press REC/STOP for about 3 seconds.
Release when the display reads B.CUT 2.
Note: Switch beat cut 1 again by following the same procedure
(the display reads B.CUT 1).
