Features - Urrea RB914A Manual De Usuario Y Garantía

storing or disposing the battery pack, cover the
terminals with a heavy insulation tape to en-
sure short circuit cannot occur. Batteries, when
stored for a long period of time, will discharge.
• Do not store or use the tool and battery pack
in locations where the temperature may reach
or exceed 50°C such as alongside sheds or met-
al structures in the summer.
• Allow the battery pack to cool down after
charging. Do not place it in a hot environment
such as a metal shed or open trailer left in the
sun.
• Only charge the battery with the charger sup-
plied.

FEATURES

KNOW YOUR TOOL
Before attempting to use this hammer drill, be-
come familiar with all of its operating features
and safety requirements.
WARNING: Do not allow familiarity with
the hammer drill to cause carelessness.
Remember that a fraction of a second of care-
lessness is enough to inflict severe injury.
1. KEYLESS CHUCK
2. TORQUE SELECTOR
3. FUNCTION SELECTOR
4. DUAL RANGE GEAR SELECTOR
5. FORWARD/REVERSE CONTROL
6. LED WORK LIGHT
7. BATTERY PACK
8. POWER BAR
9. BATTERY PACK RELEASE BUTTON
10. VARIABLE SPEED TRIGGER SWITCH
11. CHARGER
2
1
10
9
11
3
4
5
6
7
8
E N G L I S H •
CHARGER BATTERY PROCEDURE
1. Attach the battery pack
to the charger by aligning
the raised portion of the
battery pack with the slot in
the charger. Slide the battery
pack onto the charger.
2. The charger will communicate with the bat-
tery pack's circuitry to evaluate the condition
of the battery pack.
3. The POWER BAR RED LED light will lit during
charging.
4. After charging is complete, the green LED
on the charger will come ON. The POWER
BAR LED lights will not be displayed when the
POWER BAR BUTTON is pressed while the bat-
tery pack is on the charger.
5. The battery pack will fully charge, but will
not overcharge, if left on the charger.
NOTE: During the charging procedure, the bat-
tery warms up, this is normal.
POWER BAR
This Li-Ion battery pack is equipped with a
POWER BAR which is used to display the bat-
tery pack's remaining run time.
INSERTING AND REMOVING A BIT
WARNING: Remove the battery pack and set
the forward/reverse control to the locked cen-
ter position when installing or removing bits to
prevent accidental starting.
TO INSTALL
Turn the keyless chuck
counter-clockwise direc-
tion to loosen the collet,
insert the bit or other
accessory into the key-
less chuck and tighten
securely by turning the
keyless chuck clockwise
direction.
Make sure the keyless chuck is tightened in
place.
TO REMOVE
To remove the bit or accessory, turn the keyless
chuck counter-clockwise direction to loosen
the collet, and then get the bit out.
U se r's m a n ua l
Tighten
Loosen
15