Replacing The Trimmer Line On An Autocut; Mowing Head - Stihl FSA 130 R Manual De Instrucciones

English
To lubricate the gearbox:
1
► Remove the screw plug (2).
► If no grease can be seen on the inside of the screw plug,
screw the tube (1) of STIHL gear lubricant into the filler
hole.
► Squeeze no more than 0.2 oz (5 g) of STIHL gear
lubricant into the gearbox.
► Remove the tube of STIHL gear lubricant.
► Insert the screw plug and tighten it down firmly.
NOTICE
Do not completely fill the gearbox with grease.

22.4 Replacing the Trimmer Line on an AutoCut 25-2

Mowing Head

WARNING
Use of wire or metal-reinforced line is not authorized and
could be extremely dangerous. Use only the cutting
attachments recommended in this manual, in combination
with the recommended deflector.
WARNING
A damaged or loose cutting attachment or mowing head may
vibrate, crack, break or come off the trimmer / brushcutter,
which may result in serious or fatal injury or property
48
2
damage. Make sure the mowing head and cutting
attachment are properly and securely tightened and in good
condition before starting work.
► Switch off the power tool, @ 15.2.
► Remove the connecting cord, @ 14.2.
► Remove the mowing head, @ 11.5.2.
2
1
► Press both tabs (1) and remove the cover (2).
► Press down on the spool (3), turn it clockwise to release
the spool and pull up to remove it.
► Remove the remaining trimmer line (4) and dispose of it.
► If you use trimmer line with a diameter of 0.095 in.
(2.4 mm), cut a 33 ft. m (10 m) length of nylon line from
the reel and then cut it in half, making two 16.5 ft. (5 m)
lengths.
5
► Insert the first 16.5 ft. (5 m) length of line into the
eyelet (5) nearest the notches (6) until it stops.
22 Inspection and Maintenance
1
0458-725-8621-B
3
4
6