Idiomas disponibles
Idiomas disponibles
Before you start
U-handle version
1. Handle assembling bracket (upper)
2. Handle assembling bolt (8 mm)
3. Washer
4. Handle assembling bracket (lower)
5. Arrow
6. To engine
8.
Pull out the line from cover.
(A) Remove the line from "respective notch of spool", and (B)
pass it through "groove of respective eyelet".
9.
Fit cover and housing together.
(C) Align "eyelets" of cover with "recesses" of housing, and
(D) press pawls of housing into respective window of cover
until the pawls are firmly fitted into the windows.
Make sure each outer periphery of pawls of housing
spreads almost fully up to the outer periphery of respec-
tive window of cover.
If they are loosely fitted and the cutting head is turned,
cover or inside components can fly off which is danger-
ous.
U-handle assembly
Install handle assembling bracket (upper) in handle assembling
bracket (lower) and fix handle by tightening handle assembling
bolt (8 mm) lightly.
Adjust inclination of handle to adequate position (easy to oper-
ate) and tighten firmly handle assembling bolt (8 mm).
Install the handle so that it does not hide any of the
safety decals.
20
DANGER
CAUTION
