Reset; Settings For Wired Connection; Installation And Wiring - Extel VisioSmart Instrucciones De Uso E Instalación

After approximately 1 minute 30 seconds, the intercom is connected to your WiFi network.
Please note:
it will take a few hours before the smartphone can receive notifications (server updating time)

5. RESET

If there is an error and you wish to reset your intercom panel, press the black button (next to the micro SD
card) for approximately 10 seconds, then repeat the procedure from step F.

6. SETTINGS FOR WIRED CONNECTION

A. Repeat steps A, B and C of "WiFi use" instructions
B. Connect the Ethernet cable to the back of the intercom panel (the white/orange wire in TX+, the orange in TX-,
the white/green in TX+ and the green in TX-, colours according to the T568B standard). The Ethernet cable wires
must be stripped without a connector on the intercom panel end.
C. Connect the power cable to the back of the intercom panel (the red wire in V+ and the black wire in V-), then
connect it to the mains. Wait for initialisation to fi nish (approximately 2 minutes)
Note:
Push the orange levers to correctly introduce the wires.
D. Download and install the OMGuard HD application
E. Launch the application and press add camera
smartphone must be connected to the same network as the intercom). If the camera is not displayed, enter the
information manually (DID number on the back of the intercom panel).
Enter a name and the default security code 123456 and "Save".
F. Click on the image if you want to monitor the live feed. Follow the instructions to change the default security
code.

7. INSTALLATION AND WIRING

Before installing the intercom panel in its permanent location, we recommend that you carry out a test on the
jumper cables in order to check the WiFi connection. If the intercom connects to your WiFi network, you can
continue with permanent installation.
If not, proceed with wired Ethernet installation.
Important:
Do not expose the camera lens to direct sunlight or a refl ective surface.
Tip:
we recommend placing the cables inside a protective sheath to protect against breakage and bad weather.
from the App Store/Google play.
then "search". The camera ID is displayed (Please note: the
CFI EXTEL - VISIOSMART - 09/2017
(ETHERNET)
GB6