Idiomas disponibles
Idiomas disponibles
1.
Insert the long nozzle R through the air hole of the
nozzle 13 from back to front. Pass it though until the
nozzle 13 secures in place at the rear end of the long
nozzle R.
1
Fig.7
► 1. Nozzle 13 2. Long nozzle R
2.
Place the long nozzle F over the front end of the
long nozzle R. Hand screw the long nozzle F until it is
tightened securely.
1
Fig.8
► 1. Long nozzle F 2. Long nozzle R
3.
Align the guide projections on the nozzle 13 with the lock-
ing notches on the lock sleeve of the tool, then push the nozzle
13 firmly into the lock sleeve until it locks in place with a click.
6
2
Fig.9
► 1. Guide projection 2. Locking notch 3. Lock sleeve
4. Nozzle 13 5. Long nozzle R 6. Long nozzle F
NOTE: Use the long nozzle R only to have a shorter
operating range. Use both the long nozzle R and F to
allow a wider operating range.
4.
To remove the long nozzles, detach the nozzle 13
from the lock sleeve of the tool, and then disassemble
the long nozzles.
Installing and removing deflating
2
nozzles and attachments
Optional accessory
NOTICE:
deflating nozzles and attachments only while the
air vent hose complete is disconnected from the
tool. Handling the air vent hose complete assembled
into the tool may cause the tool to stand unstable
resulting in it falling over.
1.
Align the guide projections on the pinch valve nozzle
with the locking notches on the lock sleeve of the air vent
hose complete, then push the pinch valve nozzle firmly into
the lock sleeve until it locks in place with a click.
Fig.10
► 1. Pinch valve nozzle 2. Guide projections
3. Locking notches 4. Lock sleeve 5. Air vent hose
complete
11 ENGLISH
5
4
1
Always be sure to install and uninstall
5
3
2
3
2
4
1
