Idiomas disponibles
Idiomas disponibles
WARNING: This product can expose
you to chemicals including lead and
Di (2-ethylhexyl) phthalate (DEHP) which are
known to the State of California to cause
cancer and birth defects or other reproductive
harm. For more information go to
www.P65Warnings.ca.gov.
INFORMATION FOR RADIATED
EMISSION
This device complies with Canadian ICES-001.
This device complies with Part 15 of the FCC
Rules.
Operation is subject to the following two
conditions:
1) This device may not cause harmful
interference, and
2) This device must accept any interference
received, including interference that may
cause undesired operation.
WARNING: Changes or modifications
to this unit not expressly approved by
the party responsible for compliance could
void the user's authority to operate the
equipment.
NOTE: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC
Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio
communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference
by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the
equipment and receiver.
•
Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
•
Consult the dealer or an experienced radio/
TV technician for help.
Battery Charger
CHARGING PROCEDURE
NOTE: Before using the tool, read the
instruction book carefully.
CHARGING INSTRUCTIONS
1. CHARGING YOUR BATTERY PACK
WARNING: The charger and battery
pack are specifically designed to work
together so do not attempt to use any other
devices. Never insert or allow metallic objects
into your charger or battery pack connections
because an electrical failure and hazard will
occur.
2. BEFORE USING YOUR CORDLESS
TOOL
Your battery pack is UNCHARGED and you
must charge once before use.
3. HOW TO CHARGE YOUR BATTERY
CHARGING PROCEDURE
1) Plug the charger into an appropriate
outlet.
2) Slide the battery pack into the charger, The
LIGHT (1) will become green and flash to
show charging has started.
3) After charging approx 5 hours, the light
will stay green without flashing, which
means the battery is full, and charging is
completed.
WARNING:
When battery charge runs out after
continuous use or exposure to direct
sunlight or heat, allow time for the
battery to cool down before re-charging
to achieve the full charge.
CHARGING INDICATOR
This charger is designed to detect some
problems that can arise with battery packs.
Indicator lights indicate problems (see table
below). If this occurs, insert a new battery
pack to determine if the charger is OK. If
the new battery charges correctly, then the
original pack is defective and should be
returned to a service center or recycling
service center. If the new battery pack
displays the same problem as the original
Battery Pack, have the charger tested at an
authorized service center.
5
EN
