Hilti TE 30-A36 Manual De Instrucciones página 20

▶ Prior to each use and before and after prolonged transport, check the
product and the batteries for damage.
Storage
WARNING
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the product and the batteries in a cool and dry place. Comply with
the temperature limits stated in the technical data.
▶ Do not store batteries on the charger. Always remove the battery from
the charger when the charging operation has completed.
▶ Never leave batteries in direct sunlight, on sources of heat, or behind
glass.
▶ Store the product and batteries where they cannot be accessed by
children or unauthorized persons.
▶ Prior to each use and before and after prolonged storage, check the
product and the batteries for damage.
8 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable
to remedy the problem by yourself, please contact Hilti Service.
8.1 The combihammer is in working order.
Trouble or fault
The battery runs
down more quickly
than usual.
The battery doesn't
engage with an audi-
ble click.
The control switch
can't be pressed, i.e.
the switch is locked.
The drive spindle
doesn't rotate.
14 English
Possible cause
Battery condition is not
optimal.
The retaining lugs on the
battery are dirty.
The forward / reverse
switch is in the middle
position.
The permissible operat-
ing temperature of the
combihammer's elec-
tronics has been ex-
ceeded.
Battery is discharged.
Action to be taken
▶ Replace the battery.
▶ Clean the retaining
lugs and refit the
battery.
▶ Push the forward /
reverse switch to the
right or left.
▶ Allow the combiham-
mer to cool down.
▶ Change the battery
and charge the empty
battery.
2173713
*2173713*