Switching On The Device; End Of Cycle - Tecno-gaz free 3 Instrucciones De Uso

ENGLISH
8 USER INSTRUCTIONS
FILLING THE BATH
Fill the bath with water (preferably distilled)
Add the detergent, suitable for the type of cleaning to be performed, in the
percentage specified by the manufacturer.
LOADING
Place the items to be cleaned into the basket provided as standard, distributing
them evenly on the bottom of the basket. Overlapping items reduces cleaning
effectiveness.
For proper cleaning, the material to be cleaned must be completely immersed in the
cleaning liquid.
Close the bath with the cover provided

SWITCHING ON THE DEVICE

The main power switch is located above the power plug.
Turn off the main power switch when the device is not used.
Move the main power switch to I (on)
Set the cycle by entering the desired parameters.
START CYCLE
Press the START button
The start of the cycle is displayed by the corresponding flashing LED
The device displays:
Time: a fixed LED indicates the set time, a flashing LED the time remaining to the end of
the cycle.
Temperature: a fixed LED indicates the set temperature, a flashing LED the actual
temperature of the cleaning liquid.
Degas: it is enabled if the corresponding led is on
Sweep: it is enabled if the corresponding led is on

END OF CYCLE

The end of the cycle is displayed by the corresponding START / STOP fixed led
light.
Lift the cover paying careful attention to condensation.
Rotate the cover and place it close to the device.
Remove the basket and place it on top of the cover.
Proceed by rinsing the items.
18