Idiomas disponibles
Idiomas disponibles
PREPARING FOR USE
CHECKING THE ASSEMBLY OF
THE GRINDING WHEEL
Stand at the side of the grinding wheel
Start the grinder by turning the
switch to position "l"
Once started, the lamp lights up to
illuminate the sharpening area
Visually make sure the grinding wheel
does not oscillate sideways or crosswise,
consequently causing abnormal vibrations
If this should be the case, stop the machine
immediately and check if the grinding wheel
has been fitted correctly If necessary, replace
the grinding wheel with another original one
Always check a freshly fitted grinding
wheel at working speed for at least one minute
before you start grinding, standing at a safe
distance to the side of the grinder, making
sure no one else approaches the machine
CHECKING THE GRINDING WHEEL SHAPE
With the machine turned off, check the
grinding wheel (K) profile using the
measuring template (L); if necessary, dress
the wheel to restore the correct profile
16
410-120
GRINDING WHEEL DRESSING
Wear personal protection equipment
Start the grinder by turning the
switch to position "l"
Profile the grinding wheel (K) with the dressing
brick (O), always working with extreme caution,
holding it with two hands firmly and effectively
WARNING Contact with the grinding
wheel while it spins at high speed may
cause burning and abrasions
Stop the grinder by turning the
switch to position "O"
Check if the grinding wheel (K) profile is
correct using the template (L) Continue to
dress wheel until profile matches template
410-120
SETTING THE SHARPENING ANGLES
WARNING
– Wear personal protection equipment when sharpening
– All adjustments must be made with the motor switched off and the grinding wheel completely stopped
– In the case of accidental impact or collision of the grinding wheel during the sharpening process, follow
the instructions given in the "CHOOSING AND INSTALLING THE GRINDING WHEEL – WARNINGS" section
– Clean the chain before sharpening it
– To avoid overloading the motor excessively and to avoid damaging the chain cutters, grind minimum
quantities of material and do not stop along the same cutter as this could burn the cutting edge
– Do not use cooling liquids during the sharpening process
WARNING Grinding creates sparks which
could ignite flammable materials Do not
operate grinder in presence of flammable
materials or explosive atmospheres
SETTING THE SHARPENING ANGLES
17
