Idiomas disponibles
Idiomas disponibles
Scorpion 40 Installation Manual: English
Introduction
This installation manual summarizes the installation and
operation of Seagate
Note: DDS tape drives are sometimes referred to as "DAT"
The Scorpion 40 uses DDS-4 tape cartridges with a native
capacity of 20 Gbytes (40 Gbytes with 2:1 data compression).
It can also read and write older tapes using DDS-1, DDS-2
and DDS-3 tape formats. Data compression is supported for
all these formats.
The Scorpion 40 supports the following SCSI interfaces:
•
•
•
Note: The Scorpion 40 will not work in a SCSI-1
The following Scorpion 40 models are covered in this manual:
Drive model number
STD1401LW
STD2401LW
STD6401LW
Note. Additional or updated information on these drives may be
If you have purchased an external Scorpion 40, please turn to
page A-15 for installation instructions. If you have purchased
an internal drive, continue to the next page.
drives. However, only the former term is used in this
manual.
68-pin Ultra2 SCSI (LVD)
68-pin SCSI Wide (single-ended)
50-pin SCSI-2 (requires 68- to 50-pin single-ended
adapter such as Seagate PN 10006520-001)
environment.
available on Seagate's web site at www.seagate.com.
®
Scorpion 40 DDS-4 drives.
Form factor
3.5-inch internal drive
5.25-inch internal drive
External drive
A-5
