Idiomas disponibles
Idiomas disponibles
Scorpion 40 Installation Manual: English
LED codes
As shown in Figure 13 below, the front panel of the Scorpion
40 contains three LEDs. These LEDs provide information
about both normal and error conditions.
Figure 13
Front panel of internal Scorpion 40 (external drive is
similar)
Clean
LED
Clean LED
The Clean LED functions as follows:
•
•
Media
LED
If the Clean LED is ON continuously, the drive requires
cleaning. Specifically, this indicates that the drive has
been operating for at least 25 hours (for DDS-1 or DDS-2
media) or for at least 50 hours (for DDS-3 or DDS-4
media). Use only a Seagate-approved cleaning cartridge
to clean the drive.
If the Clean LED is flashing slowly, the tape cartridge
currently in use has exceeded a predefined soft-error
threshold. This signal is a warning only and does not
indicate that data has been lost. If you see this signal,
remove the tape at your earliest convenience and clean
the drive using a Seagate-approved DDS cleaning
cartridge. If, after cleaning the drive and reinserting the
original data cartridge, the Clean LED still flashes, then
you should use a new cartridge for future backups.
Drive
LED
A-23
Eject
Button
