Idiomas disponibles
Idiomas disponibles
Scorpion 40 Installation Manual: English
SCSI Termination
The internal Scorpion 40 does not provide SCSI termination.
For this reason, it should not be the last device on a SCSI
chain. Two termination examples are shown in Figure 6
below. If the drive is the only SCSI device, attach the drive to
the connector which is next to last on the SCSI chain and
attach a multi-mode terminator to the last connector in the
chain.
Figure 6
Two SCSI termination examples for internal Scorpion 40.
SCSI Terminator
SCSI Controller
(termination enabled)
Connecting a power cable
Attach a four-pin power cable to the power connector on the
back of the drive. Figure 7 on the following page shows the
location of the power connector.
The recommended 4-pin power connector for the internal
drive is an AMP 1-48024-0 housing with AMP 60617-1 pins or
equivalent.
Scorpion 40
Tape drive
(no
termination )
SCSI device
( termination
disabled )
SCSI device
( termination
enabled )
Scorpion 40
Tape drive
(no
termination )
SCSI Controller
(termination enabled)
A-15
