CAUTION!
Be sure that the mitre saw is switched off and disconnected from any current source before
assembly or any kind of adjustment.
ASSEMBLY OF THE ROTATING BASE HANDLE
Before using your double bevel mitre saw, you have to assemble the rotating base hande (J) Fig.2.
To do this, screw the handle (J). this handle is used to fix the rotating base at the desired angle for the angle-
cut.
WARNING!
Before cutting, make sure that this handle and the rotating base are blocked
BEVEL FIXING AND BASE ROTATION
The base can be blocked at 0°, 15°, 22,5°, 30° et 45° either left or right. When rotating the base, this will
automatically stop at the next position
To rotate the base, make sure that the rotating base handle is unblocked; then rotate the base at the desired
angle and block the rotating base handle in the new position
ASSEMBLING THE CLAMPS
Horizontal and vertical calmps can be assembled either on
the right or on the left of the blade and can be adjusted at
the size of the work-piece. Do not cut before having
clamped the work-piece.
Position the vertical clamp (A) Fig.3 by inserting the
clamps spindle (B) into one of the holes located on the
cut-end guide, then tighten the knob (C) to fix the spindle.
Position the horizontal clamp by inserting the spindle into
one of the holes located in the base. To adjust the clamp's
position rotate the handle or lift the lever (B) Fig.4, then
push or pull the clamp according to the work-piece
dimension.
Block the clamp in its position by lowering the lever (B)
onto the bar (A).
EN
ASSEMBLY
38
Fig.3
Fig.4