Idiomas disponibles
Idiomas disponibles
USING THE CLAMPS
1. The capacity of the clamps can be adjusted by releasing the knobs and sliding the spindles up and down
or forward and backward. Once the desired capacity is reached, tighten again the knobs.
2. while cutting, move the vertical or the horizontal clamp until the clamp's plate gets in touch with the work-
piece
3. To block the work-piece against the base, screw the knobs until the work-piece is blocked. After having
cut, open the knobs to release the work-piece.
ASSEMBLING THE EXTENSIBLE SUPPORTS
The mitre saw is equipped with two lateral extensible
supports (A) Fig.5 useful to support
during the cut. These supports can be assembled on both
sides of the machine, depending on the dimensions of the
work-piece.
Unscrew the knob (B), insert the extensions into the slots
on both sides of the base and lock the knobs again.
ASSEMBLING THE ADDITIONAL BACK
STABILISER
This mitre saw is equipped with an additional stabiliser on
the back, (A) Fig. 6, improving the machine's stability in
case of accidental release of the head, preventing it from
tilting backwards.
ASSEMBLING THE DUST COLLECTION'S BAG
insert the dust bag (A) Fig.7 into the slot (B) and verify that
it is correctly assembled.
For a better dust collection, you can connect directly to the
extracting elbow a vacuum dust collector .
Note: empty regularly the bag to prevent obstructions. The
bag is equipped with a zipper, for an easy cleaning. You
can wash the bag with soap warm water and dry it before
reusing
Make sure that the zipper is correctly closed before
cutting.
WARNING: dust particles can cause breathing problems.
For your safety we recommend to wear a protective mask, according to existing norms.
EN
long work-pieces
39
Fig.5
Fig.6
Fig.7
