Connection And Setup; Dip Switches; Priority And Emergency Activation; Speaker Outputs - Zzipp ZZONE6060PA Manual De Usuario

CONNECTION AND SETUP

With the ZZONE6xxxPA power switched off (20), connect the rear IEC inlet (21) to the mains
using the supplied mains lead (or an equivalent approved type). Ensure that the voltage is
correct and the speaker connect is correct then power on The ZZONE6xxxPA has 5 input
channels and an integral multi-source audio player.
Microphone input 1, 2 and 3 are designed for either microphones or line level sources (such
as a CD/mp3 player or output from a mixer) via combo connectors on the rear panel, it is
switch able by DIP switch. These can accept either XLR or 6.3mm plugs for balanced or
unbalanced signals.

DIP SWITCHES

Mic/Line inputs 1, 2 and 3 each have 2 DIP switches on the rear panel to set the input level
and/or activate +20V phantom power for use with condenser microphones.
Set the level correctly for the type of input source connected (Mic or Line) If the source
connected is a condenser microphone which requires phantom power, make sure that the
phantom is switched on for that channel.
Be sure to make these DIP switch settings when the amplifier is switched off. Making any
changes when the amplifier is powered up may cause loud bangs through the system which
can damage the speakers.

PRIORITY AND EMERGENCY ACTIVATION

1. Horn output- with a 24V trigger voltage will active the message build in
2. EMC input- this one is EMC audio input
3. Remote microphone ZZONE6000MC
4. Other Local input
SIGNAL INPUTS AND OUTPUTS
Connect microphones or line signals to Mic/Line 1, 2 and 3 inputs (27,28,30) using good
quality signal leads. A stereo or mono line level source can be connected to the Auxiliary
channel 4 input on 2 RCA connectors (26) For checking the output of any zone, an assignable
Monitor output can be connected to headphones from the front panel 6.3mm jack (15) or as
a line output (e.g. to active speakers) from RCA connectors at the rear (24) Each zone output
has a dedicated RCA signal output on the rear panel (23), which can be connected to the line
inputs of active speakers or amplifiers. These are in addition to the speaker outputs detailed
below. An antenna input (32) is provided on the rear panel for connection to an external
aerial for FM tuning There are Bass and Treble volume control on rear panel to adjust the
sound of MIC and Line input signal.

SPEAKER OUTPUTS

The ZZONE6xxxPA has a separate speaker output for each zone, connected via 3 large
modular terminal plugs. Each plug can be removed from the rear panel for convenient
connection of speaker outputs to 2 zones.
Each zone output can be used to power either 100V line speakers or standard low impedance
speakers. These 2 configurations cannot be used together, so it is important to decide which
will be used at the start.
6