Idiomas disponibles
Idiomas disponibles
Remove the rechargeable battery
from the device before cleaning
and maintenance.
Wear gloves when handling the
blade.
Carry out the following maintenance and
cleaning work regularly. This will guaran-
tee a long and reliable service life.
•
Do not use the unit if the blades are
blunt or worn. This will overstress the
motor and gearbox of the machine.
•
Check coverings and safety devices
for damage and correct seating. Re-
place these where necessary.
Cleaning
Remove the rechargeable battery
from the device before cleaning.
Service intervals table
Machine part
Complete ma-
chine
Accessible
screws and
nuts
Cutter head
Check correct installation
Replacing the spool
1. Remove the rechargeable batteries.
2. Place the device on the ground in a
stable position.
3. Block the mounting spindle (
using the hexagon socket wrench
(
18) as depicted.
Action
Check condition, replace dama-
ged parts as needed
Tighten
•
Clean the appliance after each use.
Clean the motor housing with a damp
cloth or a brush. The device must ne-
ither be sprayed with water nor be put
into water.
•
Keep the ventilation channels of the
device clean. Use a damp cloth or
brush to do this.
•
Do not use any cleaning agents or
solvents. This could damage the
device irreparably. Chemical substan-
ces may attack the plastic parts of the
device.
Service intervals
Carefully perform the maintenance tasks
listed in the following table on a regular
basis. Regular servicing of your unit will
extend the life of your equipment.
Additionally, you will achieve optimum
cutting performance and prevent acci-
dents.
Screw the spool cap (12) clockwise to
the mounting spindle (
4. Open the spool cap (12) by firmly
pressing the quick-release catch (43)
inwards on both sides of the spool
34)
cap (12), and remove the spool cap co-
ver.
5. Place the new spool (44) into the spool
cap cover (12) and insert the two ends
Before each
After 10 hrs of
use
use
GB
34).
133
